Page 5
For technical questions, please call 1-888-866-5797.
Item 57279
SPECIFICATIONS
Battery
Hercules 20 V HC01
Li-ion
(sold separately)
Charger
Hercules 20V HC04 Li-Ion
(sold separately)
Operating Temperature
14 - 104° F
SETUP - BEFORE USE:
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Note:
For additional information regarding
the parts listed in the following pages, refer to
Parts List and Diagram
on page 7.
Functions
1. Power Switch
2. Hook
3. Battery Pack
(sold separately)
1
2
3
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
Charging
1. Charge battery before using this tool.
Follow instructions included with battery
charger. Example instructions follow.
Battery pack and charger sold separately.
2. Place the Battery Pack on a dry fireproof surface in a
room where the temperature is between 50–104° F.
Note:
If recharging a newly spent Battery Pack,
allow it to cool completely before charging.
3. Examine the Battery Pack. It must be
undamaged, and a 12 or 20 volt, Lithium-ion
type Battery Pack.
Do not charge a cracked,
open, or leaking Battery Pack, or charge a
non-recommended type of Battery Pack.
4. The Battery Pack’s terminals are designed to fit
this Charger specifically. If the Battery Pack does
to not fit the Charger properly, do not try to insert it.
Do not force a Battery Pack into the Charger.
5. Plug the Charger into a grounded,
120VAC, 60Hz receptacle.
6. Slide the Battery Pack onto the Charger.
Note:
If the Battery Pack is hot or cold, the Charge
Indicators may both flash, indicating that the Charger
is waiting for the temperature to normalize before
Charging. Charging will start automatically once the
Battery Pack reaches the correct temperature.
7. While charging, the Battery Pack and Charger
may become warm to the touch. This is
normal, and does not indicate a problem.
8. The red LED will light constantly and the green
LED will flash when the Battery Pack is charging.
The green LED will light constantly and the red
LED will turn off when the battery is charged.
Unplug the Charger and disconnect it
from the Battery Pack when finished.
9. Allow the Battery Pack to cool
completely before using it.
10. Press the Release Button to release
Battery Pack from the Charger.
General Operating Instructions
1. Insert fully charged Battery Pack into the Flashlight,
making sure it clicks into place securely.
2. Adjust the Flashlight’s head position by
rotating it up or down to click in place
at any of the locking positions.
3. Press Power Switch once for full light
output. Press again for less light output.
Press a third time to turn light off.
4. Turn off Flashlight and remove Battery
Pack after use. Clean, then store the
tool indoors out of children’s reach.
