TROUBLE SHOOTING
17
PROBLEMS
SOLUTIONS
My audio signal is not appearing at the Stereo Master.
Have you pushed the white ´ON´ button for that channel?
.
Still no audio signal at the Stereo Master.
You need to increase the inner grey knob for more
channel volume.
Yet still no signal arriving at the Stereo Master.
You might need to increase the volume on the blue
Subgroup knob.
Even still, no signal arriving at the Stereo Master.
Have you pushed the white ´ON´ button for that
Subgroup?
Even after checking all of that, the signal still isn´t arriving
at the Stereo Master.
Make sure you haven´t pushed an INS (Insert) button
without having anything inserted or the without the
patchbay
being ´normalled´.
I´m only receiving audio on the ´Left´ side of the Stereo
Master.
Check to see if the outer ring ´PAN´ control has been set
to the extreme left side.
There is a center detent to assure equal signal to both
sides.
There is no signal at all appearing at the Stereo Master.
Double check your cables and connections.
I´d like to get a Direct Out from each channel.
Is it
possible?
Yes, of course.
Just tap the INSERT SEND signal, which
is always active.
This goes for Channels as well as
Subgroups and Stereo Master.
I´d like to have a 12 channel bus for my drums.
How
could I configure it?
Just use the first 8 channels, sent to their Subgroup 1&2.
Take the output from Subgroup 1&2 and send it to
channels 9&10.
Then at the Subgroup 3&4 you will have
channels 1-8 and channels 11-16.
So that would allow
you a drum bus of up to 14 channels.
I don´t want my AUX(FX) RETURNS hard panned Left or
Right. Is there another way to configure my setup to have
more control over their position in the stereo MASTER
Output?
Yes, by simply routing them to Channel Inputs you can
position them anywhere in the stereo field.
Just remember not to also send to the AUXs on those
channels as it will produce feedback loop.
* For any further doubts or questions please get in contact with us at:
