TROUBLE SHOOTING
PROBLEMS
SOLUTIONS
T h e r e i s a l m o s t n o s o u n d c o m i n g f r o m t h e
TUBESESSOR.
The TUBESESSOR can be an extremely transparent
compressor so even with a healthy amount happening it
can be hard to detect. Select
GR
for the Meter readout to
double check.
There still doesn´t seem to be any compression taking
place, not even registering on the Meter.
Check to see if the
THRESHOLD
is all the way down.
If
so, increase to obtain desired amount of Gain Reduction.
I´m getting way too much compression for what I need.
Try lowering the
THRESHOLD
control.
I´m still getting way too much compression for what I
need.
Try adjusting the
SC FILTER
to make the TUBESESSOR
less sensitive to the lower frequencies.
The TUBESESSOR does not seem to be reacting as it
should.
Have you allowed the recommend
10 minutes for the unit
to warm up?
The signal has decreased significantly after compressing.
Use the
GAIN
control to bring the level back up again.
The compression I am getting is altogether too aggressive
for what I am looking for.
Try a different setting on the
RATIO
control.
The compression I am getting is still altogether too
aggressive for what I am looking for.
Try different settings on the
ATTACK/RELEASE
controls
to ease back a little.
My
ATTACK
and
RELEASE
controls don’t seem to be
working.
Check to make sure you have not left the operation mode
in
FIXED
.
My TUBESESSOR is brand new but the VU meter isn’t
working.
The VU meter will not light up nor register gain reduction
until the unit is out of
BYPASS
. The Input and Output will,
however, be indicated.
I´m having trouble syncing two TUBESESSORs for stereo
operation.
Make sure you have a TS jack cable connected between
the two units and select
ON
position in the
LINK
section
for the Slave unit.
12
* For any further doubts or questions please get in contact with us at: