Heritage Bathrooms Freestanding Baths, Installation Manual

When making joints on baths (including the water and waste supplies), only use the washers provided and an 
approved joining compound, where you find it hard to make sound joints. When installing fixtures on baths, 
avoid excessive force when tightening plastic nuts.

Please ensure that the installation and accommodation is designed with future serviceability of the product 
in mind. In the event a future claim is made under the product warranty, the design of the installation may 
affect compensation costs if it has not been considered in the original design. It is strongly advisable to fit 
isolation valves before the baths water fixtures in case isolation is required at any point during maintenance.
Failure to observe crucial information in these fitting instructions will nullify your guarantee.

This product requires experience within plumbing. No responsibility will be taken for poor workmanship 
resulting in leaks and injuries.

This bath is not designed to be fitted by a wall, the minimal clearance distance must be at least 50mm. 

If you intend to fit a skirted bath on a concrete floor, please be aware that on certain models, the space 
between the waste opening and the floor may not be large enough to fit a waste trap. This will mean you will 
need to channel the waste below the concrete floor level, as seen on page 9 section 6.

04

Installation Guidelines