General Cleaning
Your fitting has a high quality finish and should be treated with care to preserve the visible
surfaces. All finishes will wear if not cleaned correctly. The only safe way to clean your product is
to wipe with a soft damp cloth. Stains can be removed using washing up liquid. All bathroom
cleaning products (powders and liquids) will damage the surface of your fitting, even the non-
scratch cleaners.
Note:
Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric
acid or phosphoric acid.
Maintenance
Cleaning the Valves
We advise that your fitting is regularly serviced in hard water areas to maintain optimum
performance. Please refer to the numbered diagram on page 5.
If your fitting begins to leak the following should be carried out;
Isolate both hot and cold water supplies to the tap by either:
Turning the water supply off at the mains stopcock or
Turning off the isolation valves to the tap.
1. Remove the indice (1) on the top of the handle to reveal the concealed screw and washer (2).
Proceed to remove the screw using a suitable screwdriver.
2. Life the handle body (3) up from the shroud (4) and unscrew the shroud itself, from the tap body.
3. Using a suitable spanner remove the valve (5).
4. Pull valve out of the tap body and clean the seating inside the tap body as well as the valve itself.
5. If necessary replace the valve.
Please visit www.heritagebathrooms.com in order to find spare parts for this product.
6. Re-place the valve into the tap body and re-connect handle assembly.
07
Cleaning the Showerhead: THRC02/THRG02
The hardness of the water in your area will determine how often you should clean your
showerhead. Build up of scale in particularly hard water areas combined with constant use means
you may need to clean your showerhead once a week. To ensure continued performance the
showerhead needs to be regularly descaled.
Tip:
If the showerhead is heavily scaled or has not be maintained for a long period of time a solution
of hot water and white vinegar may be needed to clear the scale.
Mix a 50/50 solution and rub the nozzles thoroughly with the solution making sure the solution gets
into all of the nozzles. Wash off the solution with clean water.
