(Spoke/Cast wheel version)
î
Remove the rear brake adjusting nut (1)
and disconnect the brake rod (2) from the
brake arm (3) by pushing down the brake
pedal.
REAR WHEEL REMOVAL
î
Raise the rear wheel off the ground.
î
Disconnect the brake stopper arm (4) from
the brake panel (5) by removing split pin
(6) and nut (7).
49
î
Remove the axle nut (8) and pull the axle
(9). Remove the wheel.
(1) Rear brake adjusting nut (2) Rear brake
rod (3) Brake arm (4) Brake stopper arm
(5) Brake panel (6) Split pin (7) Lock nut
5
3
1
6
7
4
2
î
Reverse the removal procedure
î
Brake stopper arm nut torque: 2.2 kgf-m
Adjust the brake
(page 39 to 40)
and
drive chain
(page 36 to 38)
.
Installation Notes
î
Axle nut torque: 5.4 kgf-m
î
After installing the wheel, apply the brake
several times and check for free wheel
rotation when released.
CAUTION
!
!
Always replace used split pins with new ones.
î
Wet the vehicle with light water spray.
Avoid directing water to muffler outlets and
electrical parts.
WASHING THE VEHICLE
Follow the below mentioned steps for washing
the vehicle.
(8) Axle nut (9) Rear axle
9
8
Summary of Contents for HF-Deluxe
Page 54: ...51 1 Canister 1...