23
(1) Ignition switch (2) Programmed FI
malfunction indicator lamp (MIL)
2
1
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
“OFF” once the engine is started.
•
Side stand indicator-
Make sure that the
side stand is up. If it is in down position the
side stand indicator
(page19)
will glow on
the speedometer panel.
•
To protect the catalytic converter in your
vehicle's exhaust system, avoid extended
idling and the use of leaded petrol.
•
Your vehicle's exhaust contains poisonous
carbon monoxide gas. High levels of carbon
monoxide can collect rapidly in enclosed
areas such as garage. Do not run the engine
with the garage door closed.
•
Fitting & Fasteners-
Check & tighten if
necessary.
•
Steering-
Check for smooth action for
easy maneuverability.
STARTING THE ENGINE
Always follow the proper starting procedure
described below :
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric
starter switch
.
•
If engine started, cranking of the engine will
stop after r/min reaches more than 850.
CAUTION
!
!
•
Turn the ignition switch (1) to "ON" ( )
position.
Preparation
Before starting insert the key and follow the
below mentioned procedure :
NOTE
Hero MotoCorp
workshop for check-up
reduce the speed and drive to the Authorised
programmed FI system. It is recommended to
If MIL remains “ON” even if the vehicle is
started, there is an abnormality in the
Ÿ
Find neutral position & check neutral
N indicator (3) on instrument console
with ignition "ON".
