50
•
Remove the speedometer cable (1) by
pressing the tab (2) & pulling cable out
from the speedometer gearbox.
•
After installing the wheel apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
•
Support the vehicle securely on the main
stand and raise the front wheel off the
ground.
(b) Front wheel (Drum type)
Removal
•
Disconnect the front brake cable (3) and
integrated brake cable (4) from the
integrated brake arm (5) and brake panel
(6) by removing the front brake adjusting
nut (7) and integrated brake adjusting nut
(8).
(1) Side collar (2) Speedometer drive gear
2
1
1
2
6
8
4
3
10
11
9
7
(1) Speedometer cable (2) Tab
(3) Front brake cable (4) Integrated brake cable
(5) Brake arm (6) Brake panel
(7) Front brake adjusting nut
(8) Integrated brake adjusting nut
(9) Axle nut (10) Axle (11) Side collar
5
•
Remove the axle (10) and side collar (11).
•
Remove the axle nut (9).
•
Remove the wheel.
Installation
Axle nut torque: 5.4 Kgf-m
•
Tighten the axle nut.
•
Install the front wheel by ensuring that the
lug (12) on the left fork is located in the slot
(13) in the brake panel.
•
Reverse the removal procedure.
