9
T-CONTROL
26
9.7
Date and time
Navigation 1:
Navigation 2:
Screen:
Screen:
By pressing the button:
By pressing the button:
the language can be set up.
the language can be set up.
the time can be set up.
NTP Server
the server name can be set up.
(The
server
receives
automatically an IP-address from
the network)
the date can be set up
Time zone
the time zone can be set up.
If NTP is active, time and date will
be updated automatically via
network (= connection to the
internet via LAN cable).
Act. Interval
the update interval can be entered
in hours (the time and date are
updated in the entered time
interval via the network, i.e. in the
entered case the time and date
are updated every 12 hours).
the screen is locked for 30
seconds (cleaning possible)
the summer of winter time gets
selected
NTP Update
a NTP update can be carried out.
The time and date will be updated
immediately.
the main menu will be displayed
i-FBR
If activated, the language setting
changes with the remote control.
Note:
NTP (Network Time Protocol) is used to synchronize date
and time automatically via the network.
A valid network connection via a LAN cable to the internet
is required.
In case of power blackout:
If NTP is active, the date and time will be updated
automatically after switch-on.
If NTP is not active, the date and time will be updated via
an internal memory up to 10 days (manufactu
rer’s data). If
boiler is more than 10 days out of service, date and time
must be set manually.
Summary of Contents for pelletstar CONDENSATION 10
