-
7
-
Eye Safety
The product is a Class 1 laser product. It satisfies the requirements of:
·
IEC/EN 60825-1:2014.
·
21 CFR 1040.10 and 1040.11 except for deviations (IEC 60825-1 Ed.3) pursuant to Laser Notice No.56, dated May 8, 2019.
Please follow the standard laser safety guidelines accordingly.
For maximum self-protection, it is strongly warned NOT to look into the transmitting laser through a magnifying product (microscope, eye
loupe, magnifying glass, etc.).
This product does not have a power switch. It starts operating once connected to power. During operation, the entire cover lens can be
regarded as the product's laser emitting window; looking at the cover lens can be regarded as looking into transmitting laser.
Product Enclosure
·
The product contains metal, glass, plastic, as well as sensitive electronic components. In case the product has been dropped and burnt,
stop using it immediately and contact Hesai technical support.
·
Do NOT squeeze or pierce the product. If the product enclosure is broken, stop using it immediately and contact Hesai technical support.
·
The product contains high-speed rotating parts. To avoid potential injuries, do NOT operate the product if the enclosure is loose.
·
Before operating the product, make sure it is properly and securely mounted. The mounting should prevent the product from leaving its
mounting position in case of external forces (such as collisions, high winds, and stone impacts).
·
If the product enclosure consists of fins or grooves, please wear gloves when handling the product. Applying too much pressure with your
bare hands may cause cuts, bruises or other injuries.
Product Enclosure: Cover Lens
·
To keep the product's cover lens from fingerprints and other stains, do NOT touch the cover lens with bare hands. If the cover lens is already
stained, please refer to the cleaning method in the
Sensor Maintenance
section of the user manual.
·
To prevent scratches, do NOT touch the product's cover lens with hard or sharp objects. If scratches already exist, stop using the product
and contact Hesai technical support. Severe scratches may affect the quality of the product's point cloud data.
Summary of Contents for Pandar40M
