EN
©2021 Hestan Commercial Corporation
16
INSTALLATION
BEFORE YOU BEGIN
BEFORE YOU BEGIN
IMPORTANT: Save these instructions for the local electrical inspector use.
INSTALLER: Please leave this manual with owner for future reference.
OWNER: Please keep this manual for future reference.
If the information in this manual is not followed exactly, electric shock, a fire or explosion may
result causing property damage, personal injury or death.
Please read these instructions COMPLETELY AND CAREFULLY. They will save you time and
effort and help to ensure optimum drawer performance.
Be sure to observe all CAUTIONS and WARNINGS. These installation instructions are intended
for use by a qualified installer.
• Assure that electrical installation is adequate and in conformance with National Electrical
Code, ANSI/ NFPA 70 (latest edition), or Canadian Electrical Code, part 1 C22.1 (latest edition)
and all local codes and ordinances. These shall be carefully followed at all times.
TOOLS YOU WILL NEED
TOOLS YOU WILL NEED
The following tools are needed to install your new warming drawer:
• Tape measure and straightedge or ruler
• Pencil
• Phillips screwdriver
• Level
• Hand or saber saw
• 1” [2,5 cm] diameter hole saw
• Drill and drill bits
• Safety gloves and goggles
• Volt meter (0-250VAC)
PACKAGING
PACKAGING
Remove all tape and packaging before using the warming drawer.
Destroy the packaging after unpacking the drawer following the rules in force in your locale.
Never allow children to play with packaging material.
