INSTALLATION
(CONT.)
CHOOSING DRAWER LOCATION
Carefully select the location where the warming drawer will be placed.
• It should be located for convenient use in the kitchen.
• Make sure that electrical power can be provided to the location selected. The receptacle
should be accessible after the drawer is installed, so that the drawer can be unplugged and
plugged in after installation. The cord is about 47” [120 cm] long.
PREPARATION
1. See drawings on following page for clearance and cutout dimensions
2. The warming drawer support surface must be a minimum 3/4” (2cm) thick plywood
platform. It must support 100 pounds.
3. The platform must be solid, level and flush with the bottom of the cabinet cut out.
4. The cabinet must be secure against tipping when the drawer is opened. Install anti-tip
brackets as needed.
5. For best performance results make sure the platform is level before placing the warming
drawer. There is no way to level the warming drawer after it has been installed.
• If the installation is not level, the door may slide open or not seal tightly, allowing heat to
escape.
CAUTION
• Use extreme caution when moving or installing the drawer. It is very heavy.
NOTICE
• DO NOT LIFT THE WARMING DRAWER BY THE DRAWER HANDLE.
• Be very careful when moving or installing the warming drawer to avoid damage to the frame
or damage to the cabinets.
• If installing the warming drawer below another product, refer to that product’s literature
for any installation requirements.
©2018 Hestan Commercial Corporation
16
EN
