background image

 

 

 

                

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic 

precautions should always be followed to 

reduce the risk of fire, electric shock, and 

injury to persons, including the following:

1.    Read all instructions before installing or using 

       this heater. 

2.    Extreme caution is necessary when any heater 

       is used by or near children or invalids and 

       whenever the heater is left operating and 

       unattended

3.    Do not operate any heater after it malfunctions. 

       Disconnect power at service panel and have 

       heater inspected by a reputable electrician 

       before reusing.

4.    Do not insert or allow foreign objects to enter 

       any ventilation or exhaust opening as this may 

       cause an electric shock or fire, or damage the 

       heater.

5.    To prevent a possible fire, do not block air 

       intakes or exhaust in any manner.

6.    A heater has hot and arcing or sparking parts 

       inside. Do not use it in areas where gasoline, 

       paint, or flammable vapors or liquids are used 

       or stored

7.    The unit must be placed with the clearance 

       of 100cm (3.5 ft) to the wall and 30cm (1 ft)

       to the ceiling. 

8.    This heater is hot when in use. To avoid burns, 

       do not let bare skin touch hot surfaces. High 

       temperature, keep combustible material such 

       as furniture, pillows, bedding, papers, clothes, 

       curtains at least 3 feet (0.9m) from the front 

       of the heater and away from the side and rear.

9.    The heater must be installed at least 2.1m 

       (7 ft) above the floor.

10.  The unit is at high temperature during 

       operation. It keeps hot for a period after shut 

       down. Potential danger would occur when 

       touching it during this period.

11.  Don't place the unit close to curtain and/or 

       other flammable objects. Otherwise there will 

       be a danger of catching fire. 

12.  Don’t cover the unit with anything during 

       operation or a short time after it's shut down. 

13.  Don't wrap the power supply cord on the unit.

14.  The unit must be handled with care, and 

       avoid of vibration or hitting.

15.  The unit must be securely grounded during 

       operation.

16.    When damaged, the unit must be repaired 

         by professional repairing team.

17.    If the supply cord is damaged, it must be 

         replaced by the manufacturer, its service 

         agent or similarly qualified persons in order 

         to avoid a hazard.

18.    The heater must not be located immediately 

         below a socket-outlet.

19.    When assembling, keep clear from any 

         board or flammable material.

20.    Do not use this heater with a programmer, 

         timer or any other device that switches the 

         heater on automatically, since a fire risk exists 

         if the heater is covered or positioned incorrectly.

21.    This appliance is not intended for use by 

         persons (including children) with reduced 

         physical, sensory or mental capabilities, or 

         lack of experience and knowledge, unless 

         they have been given supervision or 

         instruction concerning use of the appliance 

         by a person responsible for their safety.

22.    Children should be supervised to ensure 

         that they do not play with the appliance. 

23.    The head of the unit is at high temperature 

         during operation. Unplug the unit and wait 

         till it's cool before cleaning.

24.    Don't use this heater in the immediate 

         surroundings of a bath, a shower or a 

         swimming pool.

25.    Don't use this unit in place where causticity 

         or volatile air exists, i.e. dust, steam, gas, etc. 

26.    Don't use this unit as a cloth drier or 

         towel drier.

27.    Don’t use this unit as a sauna heater. 

28.    Don't use this unit as a room heater of 

         heat storing. 

29.    Don't use this unit in place of animal 

         propagating and raising.

30.    Don't use this unit in heating system of 

         hot air centre.

31.    Don't immerse this unit into water for cleaning.

32.    The unit should be plugged in a socket, 

         which is easily visible and reachable.

33.      To avoid potential fire hazards, never 

           place your heater or its electrical cord 

           under rugs, or carpeting. Place the 

           electrical cord away from busy areas 

           to avoid accidental tripping and contact.

34.      To disconnect heater, turn controls to 

           off, and turn off power to heater circuit 

           at main disconnect panel. then remove 

           plug from outlet.

35.     Use this heater only as described in 

           this manual. Any other use not 

           recommended by the manufacturer 

           may cause fire, electric shock, or 

           injury to persons.

36.     Surface temperatures become very 

           hot when operating heater. Children 

           and adults should stay away to avoid 

           burns or clothing ignition.

37.      Young children should be carefully 

           supervised when they are in the area 

           of the heater.

38. 

CAUTION

MOUNT WITH 

                      BOTTOM OF HEATER AT LEAST 

                         2.4M (8FT) ABOVE FLOOR OR 

                           GRADE.

SAVE THESE 
INSTRUCTIONS.

 

!

Summary of Contents for H1019

Page 1: ...Name 1 Expansion Bolt M6 70 2 Upper L Bracket 3 Washer 4 Spring Washer 5 Screw Nut M6 6 Screw M6 16 7 Lower L Bracket 8 Main Switch 9 Control Panel 10 Screw M6 8 11 Allen Key 12 Remote Control ACCESSORIES PACK Qty Part Name 2 Upper L Bracket 2 Lower L Bracket 2 Expansion Bolt M6 70 2 Screw M6 16 1 Remote Control 1 Allen Key 4 Screw M6 8 WARNING Use this heater only as described in this manual Any ...

Page 2: ...a desired angle and drive the Screws M6 16 tight The adjustable angle is within 60 degree totally OPERATING INSTRUCTIONS 1 Plug in the unit to a socket Make sure the power supply is same as rated 2 Press Switch on left side of the heater LED indicator light stars flashing showing the heater is on standby Press ON button on control panel or ON button on remote control to switch on the heater To shi...

Page 3: ...or similarly qualified persons in order to avoid a hazard 18 The heater must not be located immediately below a socket outlet 19 When assembling keep clear from any board or flammable material 20 Do not use this heater with a programmer timer or any other device that switches the heater on automatically since a fire risk exists if the heater is covered or positioned incorrectly 21 This appliance i...

Page 4: ...eplacement of any part or component and the shipping charges incurred for the repair or replacement and return to you of any part or component not covered by this warranty including parts or components damaged by you The company reserves the right to demand and receive written evidence of the date of purchase before undertaking its obligations under this warranty The right to demand and receive wr...

Reviews: