Hettich AG, Seestrasse 204a, 8806 Baech, Switzerland
Operator Manual_DancerPlus_EN_rev, 1.1
Page 11
2.0
Unpacking
Do not lift at the front panel or the cover!
Note the weight of the DancerPlus, see chapter 1.4 Technical data
With the adequate number of helpers, lift the DancerPlus upwards out of the cardboard
package at both sides via the folding handles, Fig. 8 no. 2 and put it in the designated place.
2.1
Transportation
The DancerPlus may only be transported when upright and with its cover closed, and it must be
switched off for a minimum of 2 hours before transportation. The shaking plate and the sample
rack are transported separately from and outside the DancerPlus, unless the rack transportation
lock is used. If the device has to be transported away from its location, e.g. to be relocated or for
repairs at the manufacturer’s or supplier’s premises, we recommend using the original
packaging, or order packaging if required
The DancerPlus must be properly disinfected, decontaminated and cleaned by the user
beforehand. Following this, we recommend attaching a decontamination declaration to the
DancerPlus.
When the DancerPlus is dispatched to the national representative or the manufacturer, a
corresponding declaration must also be included. We reserve the right not to accept a
contaminated DancerPlus. Any costs incurred for cleaning and disinfection measures shall be
invoiced to the customer. Thank you for your understanding in this matter.
