Hewlett Packard Enterprise Aruba 9012, Installation Manual

18

| Installation

Aruba 9012 Gateway

| Installation Guide

Wall Mounting

The mounting brackets can also be used for wall mounting the 9012 gateway.

Required Tools and Equipment

The following tools and equipment are required for installing the 9012 gateway:



Mounting Brackets (x2) (included in the kit)



Screws for mounting bracket (x8): M3 x 8 mm Phillips Flat Head Screws (included in the kit)



Wall Anchors: Optional accessory (not included in the kit)



Wall Mounting Screws: The type of screw depends on the installation surface (not included in the 

kit)



Suitable Screwdrivers for all screw types (not included in the kit)



Screws and Anchors recommendation:



Use 1 inch long #6 screws with #4-6 x 7/8 inch anchors



Minimum weight rating: 20 lbs / 9 kg



Required quantity: 2 screws and 2 anchors per unit

Installation Steps

To install a 9012 gateway on a wall:

1. Fasten the mounting brackets over the mounting holes on the sides of the gateway using the eight 

screws for mounting brackets (four per bracket) and a suitable screwdriver. See 

Figure 9

.

Figure 9  

Attaching the Wall Mount Brackets

2. After you have chosen a mounting location, mark the locations on a wall where you intend to 

make the mounting holes.

3. Create the holes and insert wall anchors if your installation requires them. Refer the installation 

instructions provided with the anchors being used, for details.

4. Align the mounting bracket holes with the holes you created on the wall. See 

Figure 10

.

5. Use appropriate screws to secure the 9012 gateway.

Ensure that the Ethernet ports are facing down when installing the 9012 gateway on a wall.