46
Step Command
Remarks
4.
Assign a queue to a
WRR group, and
configure scheduling
parameters for the
queue.
qos wrr queue-id
group
1
{
byte-count
|
weight
}
schedule-value
By default, queues 0 through 7 are in WRR
group 1 and have a weight of 1, 2, 3, 4, 5, 9,
13, and 15, respectively.
Select
byte-count
or
weight
according to
the WRR type (byte-count or packet-based)
you have enabled.
Configuring WFQ queuing
With a WFQ queue configured, an interface has WFQ enabled. Other queues on the interface use
the default WFQ scheduling value.
To configure WFQ queuing:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Enable WFQ queuing.
qos wfq
{
byte-count
|
weight
}
By default, byte-count WRR
queuing is used on an interface.
4.
Assign a queue to a WFQ group,
and configure scheduling
parameters for the queue.
qos wfq queue-id
group 1
{
byte-count
|
weight
}
schedule-value
By default, all queues on a
WFQ-enabled interface are in WFQ
group 1 and have a weight of 1.
Select
byte-count
or
weight
according to the WFQ type
(byte-count or packet-based) you
have enabled.
5.
(Optional.) Set the minimum
guaranteed bandwidth for a
WFQ queue.
qos bandwidth queue
queue-id min
bandwidth-value
The default setting is 0 kbps.
Configuring SP+WRR queuing
Configuration procedure
To configure SP+WRR queuing:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Enable byte-count or
packet-based WRR
queuing.
qos wrr
{
byte-count
|
weight
}
By default, byte-count WRR queuing is used
on an interface.
4.
Assign a queue to the SP
group.
qos wrr queue-id
group
sp
By default, all queues on a WRR-enabled
interface are in WRR group 1.
Summary of Contents for FlexFabric 5940 Series
Page 23: ...17 Figure 3 QoS processing flow ...
Page 84: ...78 Figure 26 MPLS label structure ...
Page 91: ...85 Switch burst mode enable ...
