84
Applying data buffer configuration
Perform this task to apply the data buffer configuration.
You cannot directly modify the applied configuration. To modify the configuration, you must cancel
the application, reconfigure data buffers, and reapply the configuration.
To apply data buffer configuration:
Step Command
1.
Enter system view.
system-view
2.
Apply data buffer configuration.
buffer apply
Displaying and maintaining data buffers
Execute
display
commands in any view.
Task Command
Display buffer size settings.
display buffer
[
slot slot-number
] [
queue
[
queue-id
] ]
Display data buffer usage.
display buffer usage
[
slot slot-number
]
Burst configuration example
Network requirements
As shown in
, a server connects to the switch through a 1000 Mbps Ethernet interface. The
server sends high-volume broadcast or multicast traffic to the hosts irregularly. Each host connects
to the switch through a 100 Mbps network adapter.
Configure the switch to process high-volume traffic from the server to guarantee that packets can
reach the hosts.
Figure 30 Network diagram
Configuration procedure
# Enter system view.
<Switch> system-view
# Enable the Burst feature.
Summary of Contents for FlexFabric 5940 Series
Page 23: ...17 Figure 3 QoS processing flow ...
Page 84: ...78 Figure 26 MPLS label structure ...
Page 91: ...85 Switch burst mode enable ...
