User manual - Machine Automation Solution - V3R003
22 / 102
setting may decrease the heating.
Autosteering pilot
Communication
failure
The system is unable to establish proper communication with the
automatic pilot controller. Check the CAN communication cables.
Autosteering pilot
Shut off remotely
The automatic pilot button or footswitch has been triggered.
Autosteering pilot
Very rough terrain
The system is unable to maintain the trajectory due to excessive cabin
swings. Ensure the inclination compensation module is securely attached.
Autosteering pilot
GNSS precision loss
The system has lost GNSS positioning accuracy. Ensure that there are no
obstacles near the antenna.
Autosteering pilot
- control message
Control message
error
The automatic pilot system is not receiving GNSS information as
expected. Please ensure that the GNSS is syncing before attempting to
operate the automatic pilot.
Pneumatic
Pneumatic
Tire pressure not reached.
CAN port
Insufficient ports
The system is configured to use both the monitoring driver and the CAN
ISOBUS, but only one CAN is available. Please reconfigure the system to
identify which will be used.
Low memory
Little available
memory
The system is operating with little available space. Export your flash files,
then delete them to free up space.
Low memory
Little available
memory
The system memory is almost fully occupied. If you proceed, the system
will become slow. Exit the current work session and start a new one.
Plate
Plates are off
Ensure that the plate sensor is working properly and that the hydraulic is
correctly engaged.
Sensor
Unresponsive sensor
The system is not reading the sensor. Please ensure that the cables and
connectors are properly installed and/or the sensor is not damaged.
Critical level
temperature
Critical system
temperature
The system is overheating and the operation has been suspended. Turn
the device off and contact technical support.
Low voltage
Power supply
– low
voltage
There is a problem with the battery to which the device is connected. The
voltage is too low or with above normal oscillation. This is common while
starting the tractor with the device turned on. In this case, it is
recommended to start the tractor with the display turned off and only turn
it on afterwards.
High voltage
Power supply
– high
voltage
There is a problem with the battery to which the device is connected. The
voltage is too high or with above normal oscillation. This is common while
starting the tractor with the device turned on. In this case, it is
recommended to start the tractor with the display turned off and only turn
it on afterwards.
Critically low
voltage
Power supply
–
critically low voltage
There is a problem with the battery to which the device is connected. The
voltage is low, which generally happens when the tractor is started with
the device turned on. If this is the case, it is recommended to restart the
tractor and then the controller.
External Wi-Fi
External Wi-Fi
disconnected
The external Wi-Fi adaptor configured for this device is not connected.
Please ensure that the adaptor is connected and not damaged.
7.2 Connectivity information
For further
GNSS information
, click on the icon located in the upper right corner.
Figure - Connectivity information
The information presented is:
