Tracker tools
H000002007-RDS User Manual
│
Version 5.0.0 (2018-09-17)
│98
E.4
MEASURE WITH THE TRACKER
Manual probing (default)
When the measurement profile is set to “Stationary”, the points are taken independently from the others:
position the probe (SMR or T-Probe), and click on the button (or press the A button on the T-Probe):
A single point is then taken.
Scan probing
When the measurement profile is set to “Continuous time” or “Continuous distance”, the points are triggered
automatically once the specified delay or distance is reached after the previous point.
Press the Measure button to start the automatic measurement
,
Then press the Stop button to pause.
Stable probing (SMR only)
RDS provides the ability to trigger automatically a point when the probe stops moving: no need to press
any button, move the probe to the desired position, as soon as it becomes stable, the point is automatically
taken.
To activate the Stable measurement, press the button
Laser scanning
Please refer to the chapter Scanner for details on the use of the scanner.
