COMPUSHIFT II Manual – COMPUSHIFT II Manual
Installation
–
35
•
•
•
•
•
•
•
3.4.2.2 Mount the Cable Bracket
Mount the cable housing and supplied bracket near the throttle linkage. As shown in the previous drawing,
the cable should be horizontal and level when attached to the Ratio Arm.
Both the cable housing and cable end have adjustable travel. To adjust the cable end, loosen the screw,
move the end to its new position and re-tighten.
The cable housing adjustment has a lock / unlock feature. Unlock the cable adjustment by pressing on the
cable housing's square button. Slide the housing as necessary. Lock by pressing the button on the opposite
side.
The cable is spring-loaded, so be sure the cable has some preload in the closed throttle position. You can
adjust the preload by loosening the cable-end screw and taking up the slack.
3.4.2.3 Mount the Sensor Box
The splashproof Sensor Box can be mounted in the engine compartment, under the vehicle or inside the
cabin.
Be sure to mount it away from the exhaust system and somewhat shielded from weather.
Use the supplied mounting tabs and sheet-metal screws. Be careful while routing the cable (avoid sharp
bends) from the cable bracket to the Sensor Box.
After installing the Sensor Box, plug in the sensor connector.
You must
not
overextend the range of travel of the TPS.
Doing so will break the sensor and void your
warranty.
If you have any questions about your ability to do this part of the job, get help from a qualified mechanic.
Our distributors and the HGM headquarters are also available to advise you.
