19
LEGAL
FCC COMPLIANCY STATEMENT
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1)
This device may not cause harmful interference
2)
This device must accept any interference received, that may cause undesired
operation.
Warning:
Changes or modification to the equipment not approved by Laney can void the user's
authority to use the equipment.
!
Note:
This equipment has been tested and found to comply with the limits for Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures.
!
Reorient or relocate the receiving antenna.
!
Increase the separation between the equipment and receiver.
!
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
!
Consult the dealer or an experienced radio/TV technician for help
--------------------------------------------------------------------------------
This product conforms to the requirements of the following European Regulations, Directives &
Rules:
CE Mark (93/68/EEC), Low Voltage 2006/95/EC, EMC (2004/108/EEC), RoHS (2011/65/EU),
RED (2014/30/EU), ErP 2009/125/EU
---------------------------------------------------------------------------------
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, HH Electronics Ltd. declares that the radio equipment type S2-210 is in compliance with
Directives 2014/53/EU, 2011/65/EU, 2009/125/EU
Full text of the EU declaration of conformity is available at the following internet address:
support.hhelectronics.com/approvals
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be
disposed of along with normal household waste to landfill sites. It must be taken to an approved
recycling centre according to the recommendations of the WEEE (Waste Electrical and Electronic
Equipment) directive applicable in your country.
---------------------------------------------------------------------------------
Bluetooth® and the Bluetooth logo are registered trademarks of Bluetooth SIG. All other product
or company names are trademarks or registered trademarks of their respective owners.
INCORPORATED RADIO EQUIPMENT DEVICE TECHNICAL SPECIFICATION:
Frequency Range:
Transmit Power:
Receiver Sensitivity:
Operating Protocol:
2402-2480MHz
+8dBm (6.3mW)
-91dBm
Bluetooth Class 2
In the interest of continued development, HH Electronics Ltd.
reserves the right to amend product specification without prior notification.
Summary of Contents for SYSTEM 2 S2-210
Page 1: ...SYSTEM 2 FULL RANGE ENCLOSURES WITH A DETACHABLE MIXER ...
Page 2: ......
Page 20: ......
