HE-MP883G User Manual
Please visit us online at
www.hittusa.com
to check if an updated manual is available
Page 30
Use “
▲
” or “
▼
” key to select, press “ESC” button to cancel the settings. Press” “
∆
” button to
confirm and return to Setup Menu.
Important:
While recording, please set the Automatic power off time to “ Never off” to avoid
turning off the PMP while recording is on.
Format
This function is to format the flash memory or External Storage Card inside this PMP, please
see figure below:
Press “
▲
” or “
▼
” button to make selection, press “ ESC” button to cancel format; Press “
∆
”
button to confirm. The screen will display “ Formatting…” which is shown as above figure. After
format is over, it will display “OK” and automatically return to format selection screen; press
“ESC” to return to the Main Menu.
9. U-Disk and USB Driver:
I) Computer configuration requirements
(1) Pentium 100MHz or higher
(2) Windows 98SE/2000/ME/XP Operating System
(3) USB Port
(4) CD-ROM Driver
(5) 16MB of Free Disk Space.
(6) 32MB of Free Memory.
II) Installation of U-Disk (USB) Driver Software:
This PMP supports Windows 2000 Operating System or above without installing USB Driver
software. If your computer’s Operating System is Windows 98SE, then USB-Driver software
from the CD must be installed so that the U-Disk function can be used on this PMP
1. Insert the CD labeled DRIVER, which came with this PMP, in your computer’s CD-ROM
Drive
2. Connect the PMP to PC with the included USB Cable when the PMP is turned on (see
next section for details on how to connect)
3. Your PC will detect new hardware and “Add New Hardware Wizard” Screen will be