22
4/2018
113175421
XR14S/16S/18S/21S/26S/30S
Hooklift Multilift XR S
User Manual
Ensure that the load´s centre of gravity is as low as possible and that it is in the middle
of the container and evenly distributed. If the load must be secured, do this when the
container is on the ground.
Ensure before loading or unloading of the container that all the removable equipment are
safely fastened and that the load space tail gate, side doors and the load’s fastening have
been checked.
Reverse the truck as slowly as possible to avoid damaging the container, the load or the
XR hooklift equipment.
If the truck is not in line with the container, position the container in line by lifting the front
end of it approx. 3.9 in (10 cm) and pulling it forward by truck. This will prevent the container
from being pulled outside the rear rollers, and the hooklift and rear lights being damaged.
When moving the container to get it in line with the truck, first remove all obstacles in front
of the container.
When loading or unloading a container, ensure that the hydraulic body locks are open. The
corresponding control unit signal light is lit when the locks are open.
Remember that the maximum permissible speed of the pump = the recommended engine
speed. Let the engine run at idle speed while switching the hydraulic body locks on and
off. Each movement must begin and end at idle speed of engine and at low speed of the
tipping cylinders. In addition the recommended pump speed (= engine speed) must not
be exceeded.
Summary of Contents for Hooklift Multilift XR S Series
Page 157: ......
