Page 26 of 38
September 2016
EntryProx User Manual, 4045-905, Rev. C.4
7.3
Programming PIN Code Only Use
To program PIN Code operation with Command 50, use the following program sequence:
1.
Place the EntryProx unit in program mode.
Press:
99 # Master Code *
2.
On the EntryProx keypad
Press:
50 # user-type # user location # keypad PIN
* keypad PIN *
3.
Press
*
to exit program mode.
7.4
Programming CARD Only Use
To program Card only use with Command 50, simply omit the keypad PIN values from the
sequence:
1.
Place the EntryProx unit in program mode.
Press:
99 # Master Code *
2.
On the EntryProx keypad
Press:
50 # user-type # user location # **
<present card>
3.
Press
*
to exit program mode.
7.5
Programming Code or Card
To program a user for either Code OR Card:
1.
Place the EntryProx unit in program mode.
Press:
99 # Master Code *
2.
On the EntryProx keypad
Press:
52 # user-type # user location # keypad PIN
* keypad PIN *
<present card>
3.
Press
*
to exit program mode.