June 2015
PLT-01952, Version: A.2
Page 3
•
The ideal installation environment described above is intended to ensure that the reader does
not read a vehicle in an adjacent lane or read vehicles that are behind a vehicle sitting at the
gate
•
It is also intended to result in an experience where the driver can go through a gate at a rolling
stop instead of coming to a full stop
•
If the reader must be mounted on a wall, it should be extended as far away from the wall as is
practical.
•
If the reader must be located along the side of a lane, then angle the reader as appropriate (see
lane drawing).
•
Avoid mounting two readers too close back to back, as shown in
. This could result in one reader interfering with the other.
2.1.1
Location
There are many items that need to be taken into consideration and planned out in detail, before the
installation will take place. The following sections cover each item.
2.1.1.1
Environment (garage, gates, etc.)
•
Where will the reader be required to be installed?
•
Does the site require EPC or SIO or both?
•
What items could cause interference?
•
Exposed to weather
•
Obstruction free area
2.1.1.2
Lane Configuration
There are many possible lane configurations that can be considered. One Possible lane configuration
is shown below:
