June 2015
PLT-01952, Version: A.2
Page 13
5
U90 Reader Management Configuration
The U90 Reader Management GUI is provided for configuration of the U90 Reader. The following is
the instructions for this process.
5.1
Preparation
Before configuring the reader the following items are required.
•
Laptop with an Ethernet connector
•
Required files for configuration (firmware updates, configuration files) loaded on the laptop
•
Ethernet cable for connection between laptop and Reader (adequate length to reach reader)
5.2
Configuration
1.
The reader must be installed and powered up.
2.
Connect an Ethernet cable from a laptop to the U90 reader (located on the bottom of the unit
under the access door).
3.
Enter the following IP address on a web browser:
192.168.63.99
.
4. The U90 Reader Management GUI will display.
5.
Login to the U90 Reader Management application. See
6.
Update the firmware if needed. See
5.3
General Information
As fields are modified, the color of the field name will change from Black to the following:
Green
: Indicates the field has been modified to an acceptable level and has been implemented in the
reader, however the change has been stored in temporary memory and will be lost if the reader is
re-booted either through a power cycle or the
Reboot System
button on the Reader Information
screen.
Red
: Indicates that the field has been modified to a value that is out of range or not acceptable. No
changes occur in the reader. The current saved value can be restored by any of the following methods:
refreshing the browser window, rebooting the reader, or power cycling the reader.
Blue
: Indicates that the value has not been accepted yet, or that the U90 Reader Management has lot
communication with the reader. No changes will occur in the reader until the field turns
Green
.
Notes
:
•
Always click Apply changes when configuration changes are made to store them in permanent
memory. If Apply Changes is not clicked the changes will be lost during a reboot or power cycle.
•
To restore settings to the values prior to the last Apply Changes, click Reboot System or power
cycle the reader.
•
Changing the Region setting will always cause the reader to reboot, all changes that have not
been applied will be lost.
•
A
Green
label will turn Black if the browser is refreshed. Changes can still be applied regardless
of label color.
