2) Pump Replacement Parts
Item
Product Description
Item
Product Description
1
Tie-in Nut
13
O-Ring
2
Tie-in
14
Difusser
3
O-Ring
15
Activities Rings
4
Drainge Plug
16
Impeller
5
O-Ring
17
Mechanical seal
6
Pump casing
18
Pump cover
7
Filter
19
Pad
8
O-Ring
20
Hexagon bolt
9
Transparent cover
21
O-Ring
10
Gland cover of Transparent cover
22
Retaining block
11
Open Cover Wrench
23
Motor
12
O-Ring
Release allairfrom filter and piping system.
In a flooded suction system (water source higher than pump), pump will prime itself when suction and
discharge valves are opened.
If pump is not in a flooded suction system, unscrew and remove trap cover; fill trap and pump with
water.
Clean and inspect Ring; re-install on trap cover.
Replace trap cover on trap; tum clockwise to tighten cover.
NOTICE: Tighten trap cover by hand only. Pump should prime now. Priming time will depend on
vertical length of suction lift and horizontal length of suction piping.
Figure 3