3. RGB Light Color Control Operation
16
pre-programmed color modes of RGB light:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
RGB Operation:
4. Maintenance and Replacement
5. Warranty
1. The manufacturer warrants this led underwater light against defect in materials and
workmanship for a period of two (2) years from the date of purchase.
2. This warranty is limited to the first retail purchaser, it is not transferable, and does not
apply to products that have been moved from their original installation sites. This warranty
does not cover failures or malfunctions from improper installation and/or operation.
3. The manufacturer is not responsible in any circumstances for assembly, installation or
start-up of any electric components which have been inserted or handled at locations other
than its own premises.
4. The liability of the manufacturer shall not exceed the repair or replacement of defective
parts. It specifically excludes liability for direct, incidental or consequential damages.
1. Any of the 16 modes can be selected with the ON/OFF switch of your pool lights.
2. Turn the light ON.
3. The 16 color modes will begin to run automatically.
4. To change the color, turn the light OFF and then ON within 15 seconds. Continue turning
OFF and ON until the desired light color mode is reached. When the light is turned OFF for
more than 1.5 seconds, it will return to the beginning of the color cycle (mode 0).
Remote Controller Options: There are 3 optional control ways
1) Power switch control, 2) Remote control (Hidro-CTRL), 3) synchrostep remote control
The color modes can also be selected with the controller. One remote control device can
be adapted to 30 pool lights simultaneously within 100 meters.
If the light is used with Direct Current (DC), a DMX 512 control and WIFI control is
available.
1. There is no maintenance required for this light. It is designed to be used only once,
meaning that replacement is necessary if it becomes defective. The repairing is impossible.
2. Before servicing the light, always disconnect the power of the circuit breaker. Make sure
there is NO power supplied to the light.
3. To replace the light, unfasten it from the bracket. Make sure the new light is the same
switch.
B-BR-R slow animation
R-B-G fast animation
RB: static purple
GREEN: static green
RED: static red
BLUE: static blue
3
BG: static cyan-blue
RGB change gradually to G/R/B
RGB: static white
G-GB-B slow animation
R-RG-G slow animation
RG-GB-BR slow animation
R-G-B fast animation
R-G-B slow animation
G-RB-B-R-RGB-GB-RG
RG: static yellow
Remark:
When the lights without internal controller option,
the light programs will keep changing by fixed automatic cycle switch.
