3.3 Instructions for Installation in Concrete Pool (PVC Pipe Ø25mm)
1) First, the ring (A) must be inserted into the underwater light, and then the underwater light is inserted into
the pipe (B) by pressure to fix it;
2) After inserting the casing (B), the ring on the back of the casing (B) will be fixed on the Ø25mm pipe by
pressure. In order to obtain the best installation effect, please follow the following sequence to push the
underwater light up so that it is flush with the wall of the concrete pool (C).
Key No.
Product Description
A
O-ring for fixing underwater light
B
Casing for 25mm Pipe
C
Concrete Pool Wall
4. Trouble shooting
1) Underwater light cannot be lit for more than 10 minutes without being immersed in water;
2) When the underwater light is installed in the swimming pool, the swimming pool should be filled with water
as soon as possible. The underwater light should not be exposed to the sun for a long time;
3) Before installing the underwater light and lighting, please check whether the underwater light is completely
immersed in the water and whether the electric box and circuit are working normally;
4) This product does not require any maintenance. If it does not work normally, please contact us.
Possible problem
Solution
Lamp Dimming
Check the control box;
If controller is connected, please check whether controller is
connected. If it is connected, check whether it is turned on.
After power on, the light
doesn't light up.
Check the connection position of the cable;
Check the fuse on the switchboard;
Replace the lamp;
Contact a qualified electrician for testing.
After power on, the light can
turn on, but it turn off after a
few seconds.
Check the control box;
Contact a qualified electrician for testing.
Figure 4
Figure 5
