HS300.4 / HS500.4 / HS800.4 4-CHANNEL AMPLIFIER APPLICATIONS
Front/Rear high pass, using a mono amplifier for mono sub bass
The combination of a 1 and a 4 channel amplifier, utilizing their built in
Channels 3/4:
crossovers, makes it a snap to put together a full system with front and rear
highs, with mono sub bass.
- HI PASS:
100 Hz
- LOW PASS:
N/A
Interconnect cable checklist:
- Using good quality RCA cables, feed the front and rear outputs of a head unit to
2 channel bass amplifier:
the inputs of the 4 channel amplifier as shown.
- Subsonic filter: 10 Hz to 40 Hz
- Also connect the
LINE OUT
of the 4 channel amplifier to the
LINE INPUT
of the
- LOW PASS: 80 Hz
1 channel amplifier as shown.
Please note that these frequency points are suggestions only. Refer to the
Mono bass woofer wiring:
loudspeaker manufacturer specifications and the section
“Setting up systems
Connect the mono speaker positive terminal to the , and its negative
after installation for best performance”
terminal to either -.
Level control checklist:
Switch setting checklist:
- Refer to the section
“Setting up systems after installation for best performance”
4 channel highs amplifier:
- 1/2CH X-OVER:
HPF
Minimum final loudspeaker impedances for 4 channel amplifier:
- 3/4CH X-OVER:
HPF
- 2 Ohm per channel in stereo mode.
- 4 Ohm mono bridged.
Crossover frequency control checklist:
- 4 channel highs amplifier:
Minimum final impedance for the mono amplifier:
- 1 Ohm
Channels 1/2:
- HI PASS: 100 Hz
LOW PASS: N/A
STEREO
INTERCONNECT
RCA CABLE
POWER INPUT
GND REM BA
TT+12V
SPEAKER OUTPUT
CH1 Ch2
Ch3 CH4
- + - + - + - +
BRIDGED
BRIDGED
FUSE
POWER INPUT
GND REM BA
TT+12V
SPEAKER OUTPUT
+ + - -
FUSE
SUBWOOFER
REMOTE TURN-ON
CHASSIS GROUND
TO B12v
VIA FUSE
4
Summary of Contents for Samson HS1500.1D
Page 1: ...SAMSON HS300 4 HS500 4 HS800 4 HS1500 1D HS2500 1D ...
Page 8: ...6 ...
Page 13: ...PART A710 ...
