High-Flying
HF-LPT100 Low Power WiFi Module User Manual
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)
- 48 -
off: TCP disconnected
4.2.2.34.
AT+UDPLCPT
Function: Set/Query UDP local port of Socket A and Socket B..
Format:
Query Operation
AT+UDPLCPT<CR>
+ok=<porta,portb><CR><LF><CR><LF>
Set Operation
AT+UDPLCPT=<porta,portb><CR>
+ok<CR><LF><CR><LF>
Parameters
porta: UDP local port of Socket A, 0: do not fix local UDP port.
porta: UDP local port of Socket B, 0: do not fix local UDP port.
4.2.2.35.
AT+SNDB
Function: Send datas to SOCKB at Command Mode
Format:
AT+SNDB=<data_lenth ><CR>
+ok<CR><LF><CR><LF>
Parameters:
data_lenth: Lenth of send data. Range: 0~1000 Byte
The UART port will wait 3 seconds for input after this command is sent OK. The data received
from UART port is sent to SOCKB. If the interval of two bytes is more than 10ms, the data will be
sent instantly.
4.2.2.36.
AT+RCVB
Function: Receive datas from SOCKB at Command Mode
Format:
AT+RCVB=<data_lenth><CR>
+ok=< data_lenth, data_content><CR><LF><CR><LF>
Parameters:
data_lenth: Lenth of receive data. Range: 0~1000 Byte
data_content: contents of receive data.
If not receive any data in 3 second, then feok=0.
4.2.2.37.
AT+WSSSID
Function: Set/Query Wi-Fi associated AP SSID parameters. Setting is valid after reset.
Format:
Query Operation
AT+WSSSID<CR>
+ok=<ap’s ssid><CR><LF><CR><LF>
Set Operation
AT+WSSSID=<
ap’s ssid ><CR>
+ok<CR><LF><CR><LF>