Friday, April 19, 2019
10
1. When the previous one is detected to be uncalibrated, the yellow light is normally
on (the green light is normally on after calibration is completed); When the previous
one is detected to be calibrated, the green light is normally on;
2. When the previous data acquisition is finished, the motor sounds (at the same
time, the green light is normally on). After the data acquisition of all six planes is
completed, and the motor will send out a sound prompt of self-inspection.
3. If the final calibration is successful, the green light flashes for three seconds. If the
final calibration fails, the red light flashes for three seconds.
Propeller replacement
The new propeller blades must rotate in the same direction as the original propeller blades. Attention
should be paid to clockwise and counterclockwise directions.
Pay attention to whether the propeller screws are loose or not, so as to avoid the danger caused by
blade falling off in flight. Every 10 hours of accumulated flight, the blades must be checked and
reinforced.
---------------------------------------------------------------------------------
※
Pay attention to whether the propeller fixing screws are loose, so as to avoid the danger
caused by the propeller falling off in flight. Check with a screwdriver every 10 hours of flight,
and tighten the loose screws at the same time.
----------------------------------------------------------------------------------
Battery charging
Please use the special charging box provided by HighGreat for charging. Refer to
the charging box instruction for the use of the charging box.
Disclaimer
