___________________________________________________________________________________________
16
www.hightechpet.com
High Tech Pet Products, Inc.
PET COLLAR OPERATING INSTRUCTIONS
Your POWER PET DOOR comes with a standard model MS-4 or MS-5
ultrasonic transmitter collar. Each collar includes a battery TEST button
which illuminates a red LED when the battery is OK. If the LED fails to
light, battery replacement is necessary.
Note:
To energize the MS-4 Collar, pull out and discard the PULL TAB
which is protruding from the side of the collar.
To energize the MS-5 Collar,
1. Pull out the PULL TAB, and discard
2. Simultaneously squeeze the case
together at both ends until fully
seated.
3. Screw in the rear screw using the
supplied #1 Phillips screwdriver.
Tighten the screw snuggly but do
not over tighten.
4. Press the TEST button and observe the Red Test Light to confirm
operation.
5. If not working, follow the Battery Replacement instruction to open the
case, remove any remaining part of the PULL TAB, and then re-seat
the battery and close up the case.