2
H
V
S
S
185 Highway 201
│
Abbeville, SC 29620
www.highvalleystoves.com
U.S. ENVIRONMENTAL PROTECTION AGENCY
Cer
fi
ed to comply with 2015 par culate emission standards.
Not approved for sale a er May 15, 2020.
Under speci
fi
c test condi ons this non-cataly c wood heater has been shown to deliver heat at rates ranging from 12,548
to 28,846 Btu/hr. Emissions were determined to be 3.1 g/hr. The default EPA e
ffi
ciency ra ng for non-cataly c heaters
was 63% at the me of this test. Results of CO (Carbon Monoxide) tes ng are not available at this me.
This non-cataly c wood heater has a manufacturer-set minimum low burn rate that must not be altered. It is against
federal regula ons to alter this se ng or otherwise operate this wood heater in a manner inconsistent with the opera ng
instruc ons provided in the owner’s manual.
This non-cataly c wood heater needs periodic inspec on and repair for proper opera on. Consult the maintenance sec-
on of this owner’s manual for further informa on.
This non-cataly c wood heater is designed to burn natural wood only. Higher e
ffi
ciencies and lower emissions generally
result when burning air dried seasoned hardwoods, as compared to so woods or to green or freshly cut hardwoods.
DO NOT BURN:
• Garbage;
• Lawn clippings or yard waste;
• Materials containing rubber, including res;
• Materials containing plas c;
• Waste petroleum products, paints or paint thinners, or asphalt products;
• Materials containing asbestos;
• Construc on or demoli on debris;
• Railroad
es or pressure-treated wood;
• Manure or animal remains;
• Salt water dri wood or other previously salt water saturated materials;
• Unseasoned wood; or
• Paper products, cardboard, plywood, or par cleboard. The prohibi on against burning these
materials does not prohibit the use of
fi
re starters made from paper, cardboard, saw dust, wax
and similar substances for the purpose of star ng a
fi
re in an a
ff
ected wood heater.
Burning these materials may result in release of toxic fumes or render the heater ine
ff
ec ve and cause smoke.
Smoke Detectors should be Installed in the living areas and bedrooms of your home. Many jurisdic ons now require
hard wired Smoke Detectors and/or Carbon Monoxide (CO) Detectors be installed in single family homes. If you are not
subject to such a requirement then ba ery operated detectors should be installed. Test them regularly and install new
ba eries every six months. A smoke detector installed in the same room as a wood heater should be situated as far away
from the heater as possible to prevent accidental ac va on when ligh ng or refueling the
fi
re. Smoke and CO detectors
should be installed per the manufacturer’s instruc ons and code requirements.
Safety Tested by:
OMNI-
Test Laboratories, Inc | Portland, Oregon
Report 512-S-01-2 | Tested 12/2012 to UL 1482-2011 & ULC S627-00
Emissions & Ef
fi
ciency Tested by:
DIRIGO
Laboratories, Inc | Clackamas, Oregon
Report 014-S-001-1 | Tested to July 1990 Particulate Emission Standards
MODEL 1300
N
-C
W
H
