—
4
—
c. When the red mark stops in a position over the mark on the belt cover, the needle up stop position disc 1
should be turned in the opposite direction as the direction of machine pulley rotation. When the red mark stops
in a position under the mark on the belt cover, Turn the disc 1 in the same direction as the pulley rotation
direction.
(2) Adjusting the needle down stop position
When the sewing machine stops in the needle down stop position, the black mark on the pulley should be
consistent with the mark on the belt cover A. Adjust as follows:
a. Turn off the power switch.
b. When the black mark stops in a position over the mark on the belt cover, the needle down stop position
disc 2 should be turned in the opposite direction as the direction of machine pulley rotation. When the black
mark stops in a position under the mark on the belt cover, Turn the disc 2 in the same direction as the pulley
rotation direction.
c. After adjusting, install the cover 3, with screw 4.
Note: There is no need to loosen the screw 5, when turning the discs.
5) Lubrication
Before the new machine is used, please loosen the screw 2 and
full the oil into the oil case. Set the oil level between “EMPTY” and
“FULL”. Then replace oil-filling screw 2.
From the library of: Superior Sewing Machine & Supply LLC
