HL 721A/B 1351B Plotting Cutter User Manual
Page 8/27
3. Press “
←
” or “
→
” arrow buttons, the pen/blade carriage will move left or right direction corresponding.
6.4. Check Y Axis (Paper Feeding Shaft Rotate Forward or Backward)
1. The red “
Reset
” LED stays on.
2. Press “
Offline/Pause
” button, and make sure the yellow LED stays on.
3. Press “
↓
” or “
↑
” arrow button, the paper feeding shaft will move forward or backward corresponding.
6.5. Check and Adjust Drawing/Cutting Speed
1. The red “
Reset
” LED stays on.
2. Press the “
↓
” or “
↑
” button to increase or decrease the setting, and LCD screen will display “Speed XXX mm/s” corresponding. (The
default setting is 350 mm/s).
6.6. Check and Adjust Blade Pressure
1. The red “
Reset
” LED stays on.
2. Press “
←
” or “
→
” button to increase or decrease the setting, and LCD screen will display “Force XXX g” corresponding. (The default
setting is 100 g).
* Make sure the blade tip should stick out about 0.5 mm or 2/3 thickness of the vinyl. Start from lower force, and then increase
it gradually.
6.7. Starting Point & Trial Cut
* Prefer to set up a ball pen on the carriage holder and load a piece of paper rather than a knife and vinyl film.
* Always do a trial-cut every time starting a new vinyl film to achieve a right cutting force.
* It is always good exercise to adjust paper feeding and carriage moving speed, draw/blade pressure, and paper feeding
wheel pressure to achieve a nice good trial.
* The machine is used to be considered as good on hardware issue if it’s able to draw/cut a trial.
Offline
/Pause
Reset
Setup
Test Origin
Blade pressure Adj.
CutSpeed 50 mm/s
CutPress 50g
1
2
Offline
/Pause
Reset
Setup
Test Origin
Cutting Speed Adj.
CutSpeed 50 mm/s
CutPress 50g
1
2
Offline
/Pause
Reset
Setup
Test Origin
Y
axis operation
1
2
3
HIGHLIGHT
ELECTRONICS
