28
WARNING
:
Turn
OFF
the
power
before
starting
the
work
so
as
to
prevent
accidents
caused
by
abrupt
start
of
the
sewing
machine.
1)Open hook cover
❶
.
2) Raise latch
❸
of bobbin case
❷
, and
remove the bobbin case.
3) When installing the bobbin case, fully insert it
into the shuttle shaft, and close the latch.
If it is not fully inserted, bobbin case
❷
may slip off during sewing.
5.
Installing the bobbin
1) Set the bobbin
❶
into bobbin case
❷
in the
direction shown in the figure.
2) Pass the thread through thread slit
❸
of bobbin
case
❷
, and pull the thread as it is. By so doing,
the thread will pass under the tension spring and
be pulled out from thread hole
❹
.
3) Pass the thread through thread hole
❺
of the
horn section, and pull out the thread by 25mmfrom
the thread hole.
If the bobbin is installed in the bobbin case
orienting the reverse direction, the bobbin
thread pulling out will result in an
inconsistent state.
6.
Adjusting the thread tension
Summary of Contents for HK2900
