29
[5]
OPERATION
OF
THE
SEWING
MACHINE
(BASIC)
1.Item
data
setting
If thread tension controller No. 1
❶
is turned
clockwise,the length of remaining thread on the
needle after thread trimming will be shorter. If it
is turned counterclockwise, the length will be
longer.
Shorten the length to an extent that the thread is
not slipped off.
Adjust needle thread tension from the operation
paneland bobbin thread tension with
❷
.
7.
Adjusting the thread take-up spring
The standard stroke of thread take-up spring
❶
is 8 to 10
mm, and the pressure at the start is 0.1 to 0.3N.
1) Adjusting the stroke
Loosen setscrew
❷
, and turn thread tension asm.
❸
.
Turning it clockwise will increase the moving amount and
the thread drawing amount will increase.
2) Adjusting the pressure
To change the pressure of the thread take-up spring, insert
a thin screwdriver into the slot of thread tension post
❹
while screw
❷
is tightened, and turn it. Turning it
clockwise will increase the pressure of the thread take-up
spring. Turning it counterclockwise will decrease the
pressure.
Summary of Contents for HK2900
