12
English
SPECIFICATIONS
Model
C1806DA
Voltage
18 V
No-Load Speed
3800 min
–1
Capacity
Cutting
depth
90°
57 mm
45°
38 mm
Weight*
3.5 kg (BSL1850C)
4.0 kg (BSL36B18)
* According to EPTA-Procedure 01/2014
Depending on attached battery. The heaviest weight is
measured with BSL36B18 (sold separately).
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
Electronic control
○
Overload protection
This protection feature cuts o
ff
the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
○
Overheat protection
This protection feature cuts o
ff
the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See
Table 1
)
●
Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1
, according to the condition of the charger or the
rechargeable battery.
Table 1
Indications of the pilot lamp
Pilot lamp
(red)
Before
charging
Blinks
Lights for 0.5 seconds. Does not light for
0.5 seconds. (o
ff
for 0.5 seconds)
While charging Lights
Lights continuously
Charging
complete
Blinks
Lights for 0.5 seconds. Does not light for
0.5 seconds. (o
ff
for 0.5 seconds)
Charging
impossible
Flickers
Lights for 0.1 seconds. Does not light for
0.1 seconds. (o
ff
for 0.1 seconds)
Malfunction in the battery or
the charger
Overheat
standby
Blinks
Lights for 1 second. Does not light for
0.5 seconds. (o
ff
for 0.5 seconds)
Battery overheated. Unable
to charge. (Charging will
commence when battery cools)
00Book̲C1806DA̲EU.indb 12
00Book̲C1806DA̲EU.indb 12
2021/05/12 10:00:58
2021/05/12 10:00:58
