6
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CF18DSL / CF18DSAL
: Cordless Steel Rebar Cutter
Read all safety warnings and all instructions.
Always wear eye protection.
Wear head protection
No open
fl
ame; Fire, open ignition source and
smoking prohibited
Keep your hands away
Keep your face away
Direct current
V
Rated voltage
D max The maximum diameter that can be cut
Disconnect the battery
Light switch: Cannot be used with this tool
Switching ON
Operates the same on either side
Remaining battery indicator switch
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Bites into rebar
Prohibited action
Warning
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 8.
Standard accessories are subject to change without notice.
APPLICATIONS
Cutting rebar to be used for reinforcing concrete
SPECIFICATIONS
Model
CF18DSL
CF18DSAL
Voltage
18 V
Cutting capacity
Up to 16 mm
diameter
Up to 20 mm
diameter
Cutting speed
4 sec.
6.5 sec.
Max. Rebar
hardness
Tensile strength 490 N/mm
2
Head angle of
rotation
345°
360°
Dimensions
(L×W×H)
370 × 90 × 306 mm
(without side handle)
413 × 103 × 316 mm
(without side handle)
Weight
6.6 kg (BSL1850) 9.4 kg (BSL1850)
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
CHARGING
For rechargable batteries, please charge in according to
the handing instruction of the charger which you are using.
(
Fig.3
)
REGARDING ENVIRONMENT AND
CONDITIONS OF USE
This tool operates on oil pressure.
When used during the winter season or in cold conditions
the hydraulic oil’s viscosity will excessively rise to dull the
tool’s operation.
In such cases, run the tool through a warm-up operation
prior to use.
How to run a warm-up operation
Without setting up a rebar, switch on the tool and let it
continuously run for 30 to 60 seconds.
WARNING
Do not place your hands in the vicinity of the piston
during warm-up operation.
Depending on the environment and conditions of use, the
hydraulics may heat up (over 50°C). This can lower the
viscosity of the hydraulic oil and reduce its cutting power.
If this occurs, allow the tool to cool down and then resume
operation.
MOUNTING AND OPERATION
Action
Figure
Page
Removing and inserting the battery
2
9
Charging
3
9
Switch operation
4
10
Regarding the switch panel
(Remaining battery indicator)
5
10
Regarding the rotation mechanism of
the tool head
6
10
Cutting
7
11
If the tool bites into a rebar
8
12
Changing the cutter block*
9
12
0000Book̲CF18DSL.indb 6
0000Book̲CF18DSL.indb 6
2017/12/05 10:26:34
2017/12/05 10:26:34
