English
30
⦁
Anchor setting
Anchor setting adapter
Anchor size
W 1/4”
W 5/16”
W 3/8”
APPLICATIONS
Rotation and hammering function
Rotation only function
○
Drilling anchor holes
○
Drilling in steel or wood
○
Drilling holes in concrete
(with optional accessories)
○
Drilling holes in tile
○
Tightening machine screws, wood screws
(with
optional
accessories)
PRIOR TO OPERATION
1. Power
source
Ensure that the power source to be utilized conforms to the power requirements speci
fi
ed
on the product nameplate.
2. Power
switch
Ensure that the power switch is in the OFF position. If the plug is connected to a power
receptacle while the power switch is in the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Extension
cord
When the work area is removed from the power source, use an extension cord of su
ffi
cient
thickness and rated capacity. The extension cord should be kept as short as practicable.
4. Mounting the tool (
Fig. 1
)
CAUTION
To prevent accidents, make sure to
turn the switch o
ff
and disconnect the
plug from the receptacle.
NOTE
When using tools such as bull points, drill
bits, etc., make sure to use the genuine
parts designated by our company.
(1) Clean the shank portion of the tool.
(2) Insert the tool in a twisting manner into the hole of front cap until it latches itself (
Fig. 1
).
(3) Check the latching by pulling the tool.
Fig. 1
Tool
Part of SDS-plus shank
Front cap
Grip
000Book̲DH24PG2̲ChS.indb 30
000Book̲DH24PG2̲ChS.indb 30
2019/02/07 14:45:17
2019/02/07 14:45:17
