English
36
(2) Adjust the depth gauge position according
to the depth of the hole and tighten the side
handle securely.
8. How to use the drill bit (taper shank) and
the taper shank adapter
(1) Mount the taper shank adapter to the rotary
hammer (
Fig. 15
).
(2) Mount the drill bit (taper shank) to the taper
shank adapter (
Fig. 15
).
(3) Turn the switch ON, and drill a hole in prescribed depth.
(4) To remove the drill bit (taper shank), insert the
cotter into the slot of the taper shank adapter
and strike the head of the cotter with a hammer
supporting on a rests (
Fig. 16
).
HOW TO USE THE CORE BIT (FOR LIGHT LOAD)
When boring penetrating large holes use the core bit (for light loads). At that time use with the
center pin and the core bit shank provided as optional accessories.
1. Mounting
CAUTION
Be sure to turn power OFF and disconnect
the plug from the receptacle.
(1) Mount the core bit to the core bit shank
(
Fig. 17
).
Lubricate the thread of the core bit shank to
facilitate disassembly.
(2) Mount the core bit to the rotary hammer
(
Fig. 18
).
(3) Insert the center pin into the guide plate until it stops.
(4) Engage the guide plate with the core bit, and turn the
guide plate to the left or the right so that it does not fall
even if it faces downward (
Fig. 19
).
Fig. 15
Drill bit
Front cap Grip
Taper
shank
adapter
Fig. 16
Taper shank adapter
Cotter
Rest
Fig. 18
Fig. 17
Core bit
Thread
Core bit
shank
Fig. 19
Guide plate
Center pin
Core bit tip
Core bit
000Book̲DH24PH2̲ChS.indb 36
000Book̲DH24PH2̲ChS.indb 36
2019/02/12 10:18:10
2019/02/12 10:18:10
