9
English
NOTE
To prevent the battery power consumption caused by
forgetting to turn o
ff
the LED light, the light goes o
ff
automatically in about 3 seconds.
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 176.
Standard accessories are subject to change without notice.
APPLICATIONS
<DS18DA>
○
Driving and removing of machine screws, wood screws,
tapping screws, etc.
○
Drilling of various metals
○
Drilling of various woods
<DV18DA>
○
Drilling of brick and concrete block, etc.
○
Driving and removing of machine screws, wood screws,
tapping screws, etc.
○
Drilling of various metals
○
Drilling of various woods
SPECIFICATIONS
The speci
fi
cations of this machine are listed in the Table on
page 175.
NOTE
Due to HiKOKI’s continuing program of research and
development, the speci
fi
cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 4
.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See
Table 1
)
●
Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1
, according to the condition of the charger or the
rechargeable battery.
Table 1
Indications of the pilot lamp (RED)
Before
charging
Lights on for
0.5 seconds and o
ff
for 0.5 seconds
Blinks
Plugged into power
source
While
charging
Lights continuously
Lights
—
Charging
complete
Lights on for
0.5 seconds and o
ff
for 0.5 seconds
Blinks
—
Overheat
standby
Lights on for
1 second and o
ff
for
0.5 seconds
Blinks
Battery overheated.
Unable to charge.
(Charging will
commence when
battery cools)
Charging
impossible
Lights on for
0.1 seconds and o
ff
for 0.1 seconds
Flickers
Malfunction in
the battery or the
charger
●
Regarding the temperatures and charging time of the
battery.
The temperatures and charging time will become as
shown in
Table 2
.
Table 2
Charger
Battery
UC18YKSL
Charging voltage
V
14.4 – 18
Weight
kg
0.35
Temperatures at which the battery
can be recharged
0°C – 50°C
Charging time for battery capacity,
approx. (At 20°C)
1.5 Ah
2.0 Ah
2.5 Ah
3.0 Ah
4.0 Ah
5.0 Ah
6.0 Ah
8.0 Ah
min
min
min
min
min
min
min
min
40
60
75
90
120
150
180
240
Number of battery cells
4 – 10
NOTE
The recharging time may vary according to temperature
and power source voltage.
CAUTION
When the battery charger has been continuously used,
the battery charger will be heated, thus constituting
the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
4. Disconnect the charger’s power cord from the
receptacle.
5. Hold the charger
fi
rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
00Book̲DS18DA.indb 9
00Book̲DS18DA.indb 9
2021/09/08 13:11:13
2021/09/08 13:11:13
