English
36
d) Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs,
fl
ush with water. If liquid contacts eyes,
additionally seek medical help.
Liquid ejected from the battery may cause irritation or burns.
6) Service
a) Have your power tool serviced by a quali
fi
ed repair person using only identical
replacement parts.
This will ensure that the safety of the power tool is maintained.
CAUTION
Keep children and in
fi
rm persons away.
When not in use, tools should be stored out of reach of children and in
fi
rm persons.
CORDLESS TRIMMER SAFETY WARNINGS
1. Hold the power tool by insulated gripping surfaces only, when performing an
operation where the cutting tool may contact hidden wiring.
Contact with a “live” wire will also make exposed metal parts of the power tool “live” and
could give the operator an electric shock.
2. Use clamps or another practical way to secure and support the workpiece to a
stable platform.
Holding the work by your hand or against the body leaves it unstable and may lead to loss
of control.
3. Always wear ear protectors when using the tool for extended periods.
Prolonged exposure to high intensity noise can cause hearing loss.
4. Handle the bits very carefully.
5. Check the bit carefully for cracks or damage before operation. Replace cracked or
damaged bit immediately.
6. Avoid cutting nails. Inspect for and remove all nails from the workpiece before
operation.
7. Make sure to securely hold the tool during operation. Failure to do so can result in
accidents or injuries. (Fig. 31 on page 57)
8. Keep hands away from rotating parts.
9. Make sure the bit is not contacting the workpiece before the switch is turned on.
10. Before using the tool on an actual workpiece, let it run for a while. Watch for
vibration or wobbling that could indicate improperly installed bit.
11. Be careful of the bit rotating direction and the feed direction.
12. Do not leave the tool running. Operate the tool only when hand-held.
13. Always switch o
ff
and wait for the bit to come to a complete stop before removing
the tool from workpiece.
14. Do not touch the bit and shaft, collet nut, collet cone immediately after operation: it
may be extremely hot and could burn your skin.
00Book̲M1808DA̲ChS.indb 36
00Book̲M1808DA̲ChS.indb 36
2021/12/01 14:42:43
2021/12/01 14:42:43
