22
English
Maintenance chart
ACTION
WHY
HOW
Clean magazine and feeder
mechanism.
Prevent a jam.
Blow clean daily.
Keep push lever working
properly.
Promote operator safety and e
ffi
cient
Nailer operation.
Blow clean daily.
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
1. Power tool
PROBLEM
CHECK METHOD
CORRECTION
Power switch doesn’t turn on.
Turn on once, but turn o
ff
automatically.
Low battery charge.
Charge the battery.
Damaged internal electronics.
Contact HiKOKI for replacement.
Push lever and/or trigger is ON state ?
Keep push lever and trigger in OFF state.
Keep no operation over 30 minutes ?
(Auto-power o
ff
function)
Push and hold power switch more than
1 second to switch “ON”
Nailer doesn’t operate
(Power switch ON).
Nailer not enough pressed against
workpiece.
Hold nailer
fi
rmly and press to the
workpiece completely.
Trigger not enough pulled.
Pull the trigger
fi
rmly.
More than 2 seconds pass from push
lever ON to trigger ON (or trigger ON to
push lever ON).
Make sure that less than 2 seconds pass
between push lever ON and trigger ON (or
between trigger ON and push lever ON).
Preventive mechanism activated.
(No nails, or too few fasteners remaining)
Reload the nails into magazine.
Lock lever (Trigger lock function) is “ON”
position.
Set lock lever to “OFF” position. (Refer to
Fig. 7
)
Machine is too cold (below -5°C) or too
hot.
Allow the nailer to cool or warm-up
throughly in adequate condition.
Damaged internal electronics.
Contact HiKOKI for replacement.
Nailer operates, but no nail is
driven.
Magazine is dirty.
Blow and wipe clean the magazine.
Check for a jam.
Clear a jam (refer to
Fig. 21, 22
).
Driver blade worn or damaged?
Contact HiKOKI for replacement.
Ribbon spring weakened or damaged?
Replace ribbon spring.
Nail feeder damaged?
Replace nail feeder.
Check for proper nails.
Use only recommended nails.
Weak drive.
Slow to cycle.
Check position of nailing depth adjustment
adjuster.
Readjust according to
Fig. 16, 17
.
Driver blade worn?
Contact HiKOKI for replacement.
Compressed air pressure has become low. Contact HiKOKI for replacement.
Damaged internal electronics.
Contact HiKOKI for replacement.
Drives too deep.
Check position of nailing depth adjustment
adjuster.
Readjust according to
Fig. 16, 17
.
Skipping nails.
Intermittent feed.
Check for proper nails.
Use only recommended nails.
Nail feeder damaged?
Replace nail feeder.
Ribbon spring weakened or damaged?
Replace ribbon spring.
Driver blade worn or damaged?
Contact HiKOKI for replacement.
00Book̲NR3675DD̲WE̲NE.indb 22
00Book̲NR3675DD̲WE̲NE.indb 22
2022/05/31 14:29:24
2022/05/31 14:29:24
