7
English
4. Never disassemble the rechargeable battery and
charger.
5. Never short-circuit the rechargeable battery.
Shortcircuiting the battery will cause a great electric
current and overheat. It results in burn or damage to
the battery.
6. Using an exhausted battery will damage the charger.
7. Do not insert object into the air ventilation slots of the
charger. Inserting metal objects or in
fl
ammables into
the charger air ventilation slots will result in electrical
shock hazard or damaged charger.
8. Do not expose directly your eye to the light by looking
into the light.
If your eye is continuously exposed to the light, your
eye will be hurt.
9. Do not give a strong shock to the switch panel or break
it. It may lead to a trouble.
10. Do not use the product if the tool or the battery terminals
(battery mount) are deformed.
Installing the battery could cause a short circuit that
could result in smoke emission or ignition.
11. Keep the tool’s terminals (battery mount) free of swarf
and dust.
○
Prior to use, make sure that swarf and dust have not
collected in the area of the terminals.
○
During use, try to avoid swarf or dust on the tool from
falling on the battery.
○
When suspending operation or after use, do not leave
the tool in an area where it may be exposed to falling
swarf or dust.
○
Wipe clean any dust, dirt, water or other liquid which
may collect on the battery connector.
Doing so could cause a short circuit that could result in
smoke emission or ignition.
12. Do not dispose of the battery in
fi
re. If the battery is
burnt, it may explode.
13. Bring the battery to the shop from which it was
purchased as soon as the post-charging battery life
becomes too short for practical use. Do not dispose of
the exhausted battery.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with
the protection function to stop the output.
In the cases of 1 to 3 described below, when using this
product, even if it is switched on, the motor may stop. This
is not the trouble but the result of protection function.
1. When the battery power remaining runs out, the motor
stops.
In such a case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this
case, switch the tool o
ff
and eliminate causes of
overloading. After that, you can use it again.
3. If the battery is overheated under overload work, the
battery power may stop.
In this case, stop using the battery and let the battery
cool. After that, you can use it again.
Furthermore, please heed the following warning and
caution.
WARNING
In order to prevent any battery leakage, heat generation,
smoke emission, explosion and ignition beforehand,
please be sure to heed the following precautions.
1. Make sure that swarf and dust do not collect on the
battery.
○
During work make sure that swarf and dust do not fall
on the battery.
○
Make sure that any swarf and dust falling on the power
tool during work do not collect on the battery.
○
Do not store an unused battery in a location exposed to
swarf and dust.
○
Before storing a battery, remove any swarf and dust
that may adhere to it and do not store it together with
metal parts (screws, nails, etc.).
2. Do not pierce battery with a sharp object such as a
nail, strike with a hammer, step on, throw or subject the
battery to severe physical shock.
3. Do not use an apparently damaged or deformed
battery.
4. Do not use the battery in reverse polarity.
5. Do not connect directly to an electrical outlets or car
cigarette lighter sockets.
6. Do not use the battery for a purpose other than those
speci
fi
ed.
7. If the battery charging fails to complete even when a
speci
fi
ed recharging time has elapsed, immediately
stop further recharging.
8. Do not put or subject the battery to high temperatures
or high pressure such as into a microwave oven, dryer,
or high pressure container.
9. Keep away from
fi
re immediately when leakage or foul
odor are detected.
10. Do not use in a location where strong static electricity
generates.
11. If there is battery leakage, foul odor, heat generated,
discolored or deformed, or in any way appears abnormal
during use, recharging or storage, immediately remove
it from the equipment or battery charger, and stop use.
12. Do not immerse the battery or allow any
fl
uids to
fl
ow
inside. Conductive liquid ingress, such as water, can
cause damage resulting in
fi
re or explosion. Store your
battery in a cool, dry place, away from combustible and
fl
ammable items. Corrosive gas atmospheres must be
avoided.
CAUTION
1. If liquid leaking from the battery gets into your eyes,
do not rub your eyes and wash them well with fresh
clean water such as tap water and contact a doctor
immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you
fi
nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the
fi
rst time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of
lithium ion battery, the battery may be shorted, causing
fi
re. When storing the lithium ion battery, obey surely the
rules of following contents.
○
Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○
To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe
the following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○
Lithium-ion batteries that exceed a power output
of 100 Wh are considered to be in the freight
classi
fi
cation of Dangerous Goods and will require
special application procedures.
000Book̲R36DA̲EU.indb 7
000Book̲R36DA̲EU.indb 7
2020/07/10 9:45:14
2020/07/10 9:45:14
Summary of Contents for R 36DA
Page 4: ...4 a 10 000Book R36DA EU indb 4 000Book R36DA EU indb 4 2020 07 10 9 45 11 2020 07 10 9 45 11 ...
Page 133: ...133 000Book R36DA EU indb 133 000Book R36DA EU indb 133 2020 07 10 9 46 01 2020 07 10 9 46 01 ...
Page 134: ...134 000Book R36DA EU indb 134 000Book R36DA EU indb 134 2020 07 10 9 46 01 2020 07 10 9 46 01 ...
Page 136: ...136 000Book R36DA EU indb 136 000Book R36DA EU indb 136 2020 07 10 9 46 05 2020 07 10 9 46 05 ...
