English
6
WHAT IS WHAT? (Fig. 1)
Since this manual covers several models, there may be
some di
ff
erence between pictures and your unit. Use the
instructions that apply to your unit.
A. Fuel cap
B. Throttle trigger
C. Starter handle
D. Fuel tank
E. Carburetor
F. Air cleaner
G. Handle
H. Ignition switch
I. Straight
pipe
J. Conic pipe
K. Guard net
L. Spark plug
M. Choke lever
N. Priming bulb
O. Recoil starter
P. Fan-headed pipe
Q. Cruise lever
R. Combi box spanner
S. Handling instructions
T. Knob volt
WARNINGS AND SAFETY
INSTRUCTIONS
Pay special attention to statements preceded by the
following words:
WARNING
Indicates a strong possibility of severe personal injury or
loss of life, if instructions are not followed.
CAUTION
Indicates a possibility of personal injury or equipment
damage, if instructions are not followed.
NOTE
Helpful information for correct function and use.
Operator safety
○
Wear head protection (1). (
Fig. 2
)
○
Always wear a safety face shield or goggles (2). (
Fig. 2
)
○
Wear approved hearing protection (3). (
Fig. 2
)
Long-term exposure to noise can result in permanent
hearing impairment.
Pay attention to your surroundings. Be aware of any
bystanders who may be signaling a problem.
Remove safety equipment immediately upon shutting o
ff
engine.
○
Always wear heavy, long-sleeved shirts (4) and long
pants (5) and non-slip boots (6) and gloves (7). (
Fig. 2
)
Do not wear loose clothing, jewelry, short pants, sandals
or go barefoot.
Secure hair so it is above shoulder length.
○
Do not operate this tool when you are tired, ill or under
the in
fl
uence of alcohol, drugs or medication.
○
Do not operate the tool at night or under bad weather
conditions when visibility is poor. And do not operate the
tool when it is raining or right after it has been raining.
Working on slippery ground could lead to an accident if
you lose your balance.
○
Never let a child or inexperienced person operate the
machine.
○
Do not start the engine if there are any
fl
ammables such
as dry leaves, waste paper or fuel in the vicinity.
○
Never start or run the engine inside a closed room or
building. Breathing exhaust fumes can kill.
○
Keep handles free of oil and fuel.
○
Keep hands away from moving part or heated area.
○
Do not grab or hold the unit by the blow pipe.
○
When the unit is turned o
ff
make sure the engine has
stopped before the unit is set down.
○
When operation is prolonged, take a break periodically
so that you may avoid possible Hand-Arm Vibration
Syndrome (HAVS) which is caused by vibration.
WARNING
○
Always operate the tool with proper protective equipment
and clothing. Failure to do so may result in accidents
such as burns or injuries. (
Fig. 2
)
○
Do not touch the spark plug area or high voltage during
operation. Doing so may result in electric shock.
○
Do not allow children near the tool during operation.
○
Do not touch the engine, top cover or exhaust vent
during or shortly after operation. Doing so may result in
burn or injury.
○
Antivibration systems do not guarantee that you will
not sustain Hand-Arm Vibration Syndrome or carpal
tunnel syndrome. Therefore, continual and regular users
should monitor closely the condition of their hands and
fi
ngers. If any of the above symptoms appear, seek
medical advice immediately.
○
Since this product is engine driven, make sure to wear
the proper protective equipment to minimize the e
ff
ects
of vibration and sound to your body. Limit a single
continuous operation between 30 to 40 minutes, and rest
for 10 to 20 minutes. Also, limit your day’s work time to
80 minutes.
○
If you are using any medical electric/electronic devices
such as a pacemaker, consult your physician as well as
the device manufacturer prior to operating any power
equipment.
○
If trash or collected waste including fallen leaves become
trapped in the machine, make sure to cut the engine and
remove the debris before resuming use. Using the machine
without removing the obstructions may result in damage.
Unit/machine safety
○
Inspect the entire unit/machine before each use.
Replace damaged parts. Check for fuel leaks and make
sure all fasteners are in place and securely tightened.
○
Replace parts that are cracked, chipped or damaged in
any way before using the unit/machine. Faulty parts may
increase the risk of accidents and may lead to an injury.
○
Keep others away when making carburetor adjustments.
○
Use only accessories as recommended for this unit/
machine by the manufacturer.
○
Before operation, make sure that there are no tools such
as the adjustment key or spanner still attached to the unit.
WARNING
○
Never modify the unit/machine in any way. Do not use
your unit/machine for any job except that for which it is
intended.
○
Tampering with the engine voids the EU type approval of
this engine.
○
Non-authorized modi
fi
cations and/or accessories may
result in serious personal injury or the death of the
operator or others.
○
The guard net must be
fi
rmly
fi
xed in place.
Fuel safety
○
Mix and pour fuel outdoors and where there are no
sparks or
fl
ames.
○
Use a container approved for fuel.
○
Move at least 3 m away from fueling site before starting
engine.
○
Stop engine before removing fuel cap. Do not remove
the fuel cap during operation.
○
Empty the fuel tank before storing the unit/machine. It is
recommended that the fuel be emptied after each use. If
fuel is left in the tank, store so fuel will not leak.
000Book̲RB27EAP.indb 6
000Book̲RB27EAP.indb 6
2018/12/14 9:11:25
2018/12/14 9:11:25
