English
25
9. Do not use the charger continuously.
When one charging is completed, leave the charger for about 15 minutes before
the next charging of battery.
10. Do not allow foreign matter to enter the hole for connecting the battery.
11. Never disassemble the battery and charger.
12. Never short-circuit the battery.
Short-circuiting the battery will cause a great electric current and overheat. It
results in burn or damage to the battery.
13. Do not dispose of the battery in
fi
re.
If the battery burnt, it may explode.
14. Do not insert object into the air ventilation slots of the charger.
Inserting metal objects or in
fl
ammables into the charger air ventilation slots will
result in electrical shock hazard or damaged charger.
15. Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
16. Using an exhausted battery will damage the charger.
17. Do not use the product if the tool or the battery terminals (battery mount) are
deformed.
Installing the battery could cause a short circuit that could result in smoke
emission or ignition.
18. Keep the tool’s terminals (battery mount) free of swarf and dust.
○
Prior to use, make sure that swarf and dust have not collected in the area of the
terminals.
○
During use, try to avoid swarf or dust on the tool from falling on the battery.
○
When suspending operation or after use, do not leave the tool in an area where it
may be exposed to falling swarf or dust.
Doing so could cause a short circuit that could result in smoke emission or
ignition.
CAUTION ON LITHIUM
-
ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the protection function to stop
the output.
In the cases of 1 to 3 described below, when using this product, even if you are pulling
the switch, the motor may stop. This is not the trouble but the result of protection
function.
1. When the battery power remaining runs out, the motor stops.
In such case, charge it up immediately.
2. If the tool is overloaded, the motor may stop. In this case, release the switch of tool
and eliminate causes of overloading. After that, you can use it again.
3. If the battery is overheated under overload work, the battery power may stop.
In this case, stop using the battery and let the battery cool. After that, you can use
it again.
00Book̲WH18DE̲ChS.indb 25
00Book̲WH18DE̲ChS.indb 25
2022/01/28 9:54:40
2022/01/28 9:54:40
