◆
◆
◆
◆
●
●
●
●
●
●
●
●
●
●
●
●
●
●
CAUTION
IMPORTANT
OPERATION INSTRUCTION
General
Before each use:
Always operate, inspect and maintain tool in accordance with all regulations (local, state,
federal and country), that may apply to hand held pneumatic tools.
Drain water from air compressor tank and condensation from air lines. See air
compressor’s operation manual.
Disconnect the tool from the air supply before lubricating,
installing, removing or adjusting the tool.
Lubricate tool, see “Maintenance“ section in this manual.
Select the required drilling bit depending on the material to be work on .
Connect tool to air hose of recommended size.
NOTE:
The use of a quick connect set makes connecting easier.
The use of air filters and air line lubricators is recommended.
To use:
Turn air compressor on and allow air tank to fill.
Set the air compressor’s regulator to 90 PSI (6.2 bars). This tool operates at a maximum
90 PSI
(6.2 bar)
pressure.
For rotating tools, make sure the direction of rotation before operating tools.
Make sure the inserted tool is firmly secured by the chuck (drill/tappers), by the retainer
(hammers/needle scalers), by the bit holder (screwdrivers), by the collet (die grinders), by
the flange set (grinders), blade holder (saws) or firmly attached to the anvil (impact/ratchet
wrenches) or the pad (sanders/polishers).
Setting for the rotational direction, if any:
Pull the level/switch as it is marked on the tool.
「
F
」(
Forward) - Clockwaise direction seen from the operator ’s position.
「
R
」(
Reverse) - Counter-clockwaise direction seen from the operator’s position.
Note: For some tools, it may marked with the combination of
「
L
」
and
「
R
」
. In this case,
「
R
」
(right) indicates the forward direction and
「
L
」
(Left) indicates the reverse
direction.
Setting for the rotating/reciprocating speed settings, if any:
by digits: greater number indicates a hight setting and vice versa.
by symbols: greater size of the symbol indicates a hight setting and vice versa.
Note: Always start operating with a lower setting.
Allow the tool to stop completely before changing the direction of rotation.
To Start or Stop
The tool equips with a hold -to-run trigger/level. Pull the trigger (or press down the lever) to
start the tool. The tool will stop running when t he trigger/lever is released.
Note: For certain kinds of air tools, it might take some seconds for the tool to stop
completely because of the inertia.
Summary of Contents for WR14A
Page 1: ...WR14A WR27A...
