ID7000 Series Smart Code Reader User Manual
51
Control Settings
→
Output
→
Line Out Inverter
to enable it.
Note
The
Line Out Inverter
function is disabled by default.
Figure 9-26 Enable Line Out Inverter
9.5 Code Reading Result Settings
In
Data Processing
module, you can set filter rules for reading codes and other data processing
related parameters.
9.5.1 Set Filter Rule
You can set rules to filter unwanted codes to improve the reading efficiency in
Filter Rule
.
Note
The filter rule parameters may differ with device mode and trigger mode you select. Here we take
normal device mode and internal trigger mode as an example.
Instant Output Mode Enable
If this parameter is enabled, the device can instantly output code reading result when recognizing
codes. If it is not enabled, the device will not output code reading result until the trigger stops.
Min. Output Time
It sets the min. waiting time before data output. For example, if you set 500 ms as
Minimum
Output Time
, the barcode would not be outputted until 500 ms is passed.
Numeral Filter
If this parameter is enabled, the device will only parse and read the numeral contents of the
barcodes, and the non-numeral contents will be filtered out.
Max Output Length
It sets the max. code length that can be outputted.
Code Offset Num
